Handles should be designed for bare or gloved hand operation. Handles should be located at or above the center of gravity of the load. Handles should be textured to reduce slippage, but should NOT be …

Tighten the handle assembly with the provided handle screws. 1. Close the screen door and center the strike on the inside handle latch and mark the position for the screw holes. See figure 2. 2. Drill …

Joining an ax head to a handle is relatively easy, but it is not necessarily a quick procedure. You may have to fit, remove, adjust, and refit the handle numerous times to achieve a proper fit. If necessary, …

These handles are designed to be used with Bulletin 194R fused and non-fused disconnect switches up to 60 A, Bulletin 140U/UE Molded Case Circuit Breakers, Bulletin 140M Motor Protection Circuit …

Your storm door lock can be re-keyed to match your main door’s handle set if it’s a Kwikset® (included) or a Schlage® (additional purchase required). Many home improvement stores or locksmiths can …

e handle in the tool. To remove an epoxy fastened handle, carefully heat the tool with a torch, or in an oven, to a rang of 250°F to 350°F. This will soften the epoxy enough so that the tool can be driven off

1. If not pre-assembled, insert handle into handle housing (Fig 2). 2. Place spring onto spindle, as shown, and insert into handle assembly (Fig 3). 3. Push this assembly through drilled holes from the …